The Sound Post – Soul of the Violin

A sound post is a small piece of dowel made of well-aged European Spruce. Despite its rather insignificant appearance, a sound post is the soul of a bowed stringed instrument like the violin. Its exact location is critical to ensure perfect sound transmission.


A soundpost hand made in Ilja Grawert Violinmaker Brisbane Workshop A sound post in its location inside the Violin

Location:
The sound post stands inside the violin connecting the top-plate and back-plate and is located slightly below the right hand bridge foot. It is standing up only under tension, not glued to the inner surfaces of the plates. It therefore has to  stand under the correct tension; too loose and it will fall over, too tight and it will damage the plates. Its end-grain surfaces have to fit perfectly to the inner surfaces of the plates of the violin.


Tool to measure the inside of a ViolinTools you need to fit and set and adjust a sound post

The sound post has to be at a certain spot behind the right hand foot which is different in every violin but follows a strict set of rules depending on the build, shape and density of the plates.
If the sound post is moved only a tenth of a millimetre away from that place the whole violin will not sound as beautiful any more.


Sound post on a sound post setter It takes years and years of experience to be  able to put the sound post in the right place, fitting to the inner surfaces, under the right tension at the right spot.
Many inexperienced people have tried to move it themselves or fit new one without the right tools and knowledge and have

destroyed the inner surfaces of their valuable and irreplaceable Master violins.

Fitting the sound post:
With a special tool I measure the inner distance between top and back and roughly cut a piece of already prepared spruce dowel to the right length.
The end-grain surfaces I cut with a very sharp carving knife to an angle similar to the arching of the plates.


Inserting a sound post through the f holeThe Brisbane Violin Maker Ilja Grawert is inserting Sound post through the f-hole
Sound poust being set inside the ViolinMoving Sound post inside the Violin
Ilja Grawert is moving the soundpost inside the Violin to the right position

Then I stick the sound post to the special tool called a sound post setter and carefully insert it into the violin through the f-hole and stand it up in roughly the correct position.

I then look through the little end-pin hole and check how well it is fitting.


looking through the endpin holelooking through the endpin hole
looking inside the Violin through the endpin hole
In order to be able to see the other side of the sound post I use a little dentist mirror.
This whole procedure is repeated until the sound post fits perfectly in the right spot under the right tension.

After that it can still be moved around to fine tune the instrument.

The finished soundpost in its right location

If the sound post is in the right spot in relation to the violin and to the position of the bridge, the violin will have a beautiful, even, carrying sound and the strings will speak easily when played with the bow.

It truly gives the violin’s sound its soul.


Leave a Reply

2 Comments on "The Sound Post – Soul of the Violin"

Notify of
avatar
Sort by:   newest | oldest | most voted
caosesvdia
Guest

nice article and pictures, thanks for taking the time to do that.

Raaouf
Guest

Perfect description, very helpful thanks indeed

wpDiscuz